Categories
General

Step by Step Window Replacement

This article covers the tools and main steps required for a window replacement job. The supplies you will need to buy are: a replacement window and window frame. It should be of slightly smaller size for easy mounting into the existing frame. You will also need weatherproof wood putty to patch any holes in the frame. Polyurethane foam should be used to insulate the space around the window, but make sure it is of the minimally expanding variety or you will need to be careful about over-expanding warping the windows’ frame. top windows Toronto

Wood shims are used to plumb and level the window and snugly adjust its position in the portal opening. Sandpaper smoothes the window frame for finishing, whether that be by paint or sealant. Screws are needed to fasten the window to your studs. Use insulating foam rods to fill any gaps between caulk and expanding foam. The window may need window stops if the old ones broke. Paint and primer are used to finish the frame.

If the window opening you want to put replacement windows in is still square, you can simply use a construction window from a Denver replacement windows company. Vinyl windows are a good choice because vinyl needs minimum maintenance. For the full energy-economy effect, choose a vinyl covered wooden window with low-e insulated glass.

The first step before you can go grab replacement windows in Denver is to measure what you are replacing. Use a slightly smaller glass measured according to the manufacturer’s specifications. Now you are ready for the actual removal. Take out the lifting sash. Then pry off the jamb liners and any trim. Prep the frame for installation by marking and placing all the connecting areas. Remove the old sash weights. Modern windows have a simpler interior spring mechanism. This will leave an air space that must be filled if our new window is to do its proper insulating job. So next you need to prep and spray in insulating foam, being sure not to spray too much of the expanding substance. Then caulk between all moving parts.

Your next step is the installation of your replacement windows. This involves fastening it loosely in place while you shim the window to fit snugly plumb and level. To finish caulk, prime and paint your window.